Huddly Canvas installation guide

Here are the steps for setting up Huddly Canvas.

Before you begin, you will need the following (not included in the Canvas package):

• CAT 5e/6/7 Ethernet cable
• 4 screws suitable for your wall type (5 mm diameter, or #10 screw)
• Whiteboard up to 2 m x 1.2 m/6' x 4'

Once you have all the necessary components, please follow these steps:

Placing the wall bracket

• Place the wall bracket 14 cm/5.5" above the center of your whiteboard.
• Mount the wall bracket with the tabs facing out.
• Secure the wall bracket using four screws.

Connect the Huddly Canvas camera

• Rotate the camera arm so that it points down.
• Fasten the Huddly Canvas camera with the camera screw.
• Connect the USB cable to the camera.

Place the housing to the wall bracket

• Place the Canvas housing over the wall bracket and slide it down carefully until it is safely in place.

Connect the Ethernet cable

• Connect your Ethernet cable to the top of the Canvas housing.

Connect the cables

• Connect the other side of the Ethernet cable to the included USB extender.
• Use the included USB cable to connect the USB extender to your meeting room computer.
• Connect the AC Power Adapter to the USB extender and a power socket.

Finish the installation

• To finish the installation, visit huddly.com/canvas/setup .

You can see the attached PDF for visuals.